 |
| part way through assembly of the model with PVA |
 |
| layers building up |
 |
| the roof section, was very difficult to get the cuts to match exactly in illustrator as the shape of the object tapers so each layer is different. Was also difficult to match the holes up exactly over 6 layers as some of the holes were only 1x1mm and would easily be covered over if the layers were not placed exactly on top of one another. |
 |
| light coming through the perforations |
 |
| layers building up before the roof section went on |
 |
| finished model without roof section applied |
 |
| plan view |
 |
| side elevation |
 |
| side elevation |
 |
| end elevation (entrance) |
 |
| end elevation (rear) |
No comments:
Post a Comment